Tender driving skills

As I sit and watch tenders or Dingy’s being driven around anchorages it strikes me this is a gap in our training programs.

There was a saying was that many people feel they don’t need to learn to drive a car or make love... ( a fallacy on perhaps both counts for many) , perhaps we need to add drive a tender to that list ? At any rate we can all improve in our endeavours with a little upskilling and helpful advice .

Whether it’s on the road in the bedroom or on the water . Speed and distraction are always your enemy .

A yachts tender may take many forms but over the years has morphed from the 8ft pram dinghy under oars I used to love rowing as a kid to a high speed RIB with usually a 15hp engine . The rowing boat kept you healthy and others safe . The RIB is superb for covering distance , carrying heavy loads and sadly killing swimmers , turtles and anything else in your path . Many spend hours considering all sorts of safety equipment from EPIRBS to the right satellite communicator or personal locator yet don’t consider the biggest risk factors . If you don’t concentrate and or use a kill cord your RIB will run over you if you mess up a high speed turn . Similarly at 25-30 k you have little chance of seeing a swimmer checking the anchor of the yacht your admiring .

You are the captain of that vessel your driving.
You may seriously wound or kill someone including yourself.
You are liable to be charged with manslaughter if you kill the person on the water operating at unsafe speed .
You will never forgive yourself .

So many times I see a near miss.

So please use a kill cord and go slowly through anchored yachts .
Think carefully about the consequences .

Please have a sober tender driver after a session ashore and can I encourage the RYA to consider that a yachtmaster who cannot train and ensure that dinghy drivers , handle boats safely is not much of a yacht master at all .





Yours Aye
Nigel

+x

 

Nigel Studdart - 10/6/2020

This casualty was a 4m tender with a 15 or 25 hp engine on it running at full speed so I’m guessing the friction control on the throttle was also tight .One other learning from this is keep that friction loose so the throttle goes back to low speed if you release . That engine and boat were positively demonic at that speed and incredibly difficult to deal with.

Good work Nigel,
Quite a story. The man was very lucky and I am glad you were unhurt.
It pains me to say that I would completely support you not doing anything more than rescue the swimmer next time. It is not worth getting hurt dealing with someone else’s poor judgment.
Now anyone can suffer from bad luck, but there are just too many out there now on boats who should not be: They are unprepared and using poor judgment. I have focused on boats doing offshore passage making in my writing, but you are absolutely correct in pointing out the same dynamic in an anchorage. You could have been hurt. SAR personnel could be hurt when they go out for a rescue. Too often, as was your rescue, it should not have occurred in the first place.
I hope the man came by later with a nice bottle of wine: or better.
My best, Dick Stevenson, s/v Alchemy